Here are some photos of the Triple EG in progress. The panel is a tight fit, but all the controls and spacers for the PCBs fit, which is the important thing.
Note on the Power/Regulation PCB, I did not add any regulators since this module runs on +12 volts only. I put a jumper for the +12 volt regulator and the two filter caps, ferrite bead, and diode.
Also note the production version of this PCB has the trigger conversion circuitry on the PCB itself. This prototype is missing the conversion.
Next, I will stuff the two ENVDL PCBs.
No comments:
Post a Comment